Kimitech EP-TX

Kimitech EP-TX is CE marked as structural bonding according to EN 1504-4 and as an anchor for steel reinforcement according to EN 1504-6. The product is part of the Kimia certified systems by Italian CVT n. 405.

For the realization of the various types of intervention, read the technical specifications and the technical data sheets of the materials to be used. The product is supplied in pre-dosed packages with a 1/1 resin/hardener ratio to be easily applied on site in small doses without mixing errors (the two products are different in color). Mix part A (resin) perfectly with part B (hardener) until you get an even color and apply with a spatula on perfectly clean, dry, dust-free surfaces and inconsistent parts. Sandblast both concrete and metal surfaces to remove cement laitance and extrusion slag. It is always advisable to apply Kimicover FIX in porous substrates (compulsory passage in case of application of reinforcement fabrics or plates). Mix the amount of resin you expect to use within the frost time. In case of protective coating, it can be loaded with Kimifill 01-03. STRUCTURAL REINFORCEMENT WITH COMPOSITE SYSTEMS Preparation of the surfaces subject to reinforcement and application of two-component water based epoxy primer Kimicover FIX. Carefully mix the two components Kimitech EP-TX and apply the product in an even layer with an iron spatula, respecting the consumptions shown in the following Technical Data Sheet; when dry, lay the fabric and, with a suitable metal roller, press lightly on it to facilitate adhesion and avoid the formation of dangerous air bubbles. When dry, impregnate the fabric with Kimitech CMP fluid resin. If you wish to make more reinforcement layers, contact our Technical Department. When laying Kimitech PLATE, Kimitech EP-TX adhesive layer must be spread both on the substrate and on the surface of the plate involved in bonding.