Kimifloor ECO BASE

On the suitably prepared substrate, proceed with the application of the primer Kimicover FIX MV, Kimitech 350 mesh with a coat of Kimifloor ECO-BASE not loaded and, once hardened, the application of a first coat of Kimifloor ECO-BASE with Kimifill aggregates. Apply the material with a white plastic spatula if you do not want to have dark marks on the applied product (if this effect is required, use metal spatula). It is advisable not to perform thicknesses greater than 1 mm in a single solution, otherwise, during the hardening process, shrinkage micro-cracks could occur with excessively long drying times. Later coats will be spread (waiting at least 1 day between one application and another) after sanding, aspiration, and priming with Kimitech K60. The aggregates added in the last coat of Kimifloor ECOBASE, if sanding is particularly energetic, could be exposed, with the relative color. Depending on the desired effect, sand so as to highlight them in a more or less marked way. Deep sanding that is not perfectly homogeneous could generate disordered chromatic effects. In this case, it is possible to use a higher colored paint to uniform the color of the surface. The system is finished by applying Kimifloor ECOFINITURA one-component polyurethane resin (pigmentable for particular glazes and color effects) or Kimifloor VETRO two-component epoxy (in case of enhancement of the three-dimensionality of material textures or incorporation of particular decorative elements) . All interventions must be protected with a double final coat of Kimifloor ECO-FINITURA PLUS two-component polyurethane water-based diluted 10% with water.