Kimitech PLUG VR

Kimitech PLUG VR connectors are part of the Kimitech WALLMESH MR SYSTEM and Kimitech WALLMESH HR SYSTEM systems with CVT n° 317.
 

Make sure the substrate is completely hardened, resistant and free of loose parts. In the presence of existing degraded plaster, strip the surface until obtaining a substrate with sufficient resistance. Clean and saturate the substrate by low-pressure washing. Remove any efflorescence and salts by washing or mechanical systems such as brushing, sandblasting or hydro-sandblasting.
On particularly irregular or poorly absorbent substrates, before applying the structural mortar, provide a rough coat.
The temperature of the substrate must be between +5°C and +30°C. After carefully preparing the substrate, before applying the first layer of lime-based structural mortar, wet with low-pressure water until completely saturated; any lack of saturation could cause the mortar to not adhere and crack. Apply by hand (with a stainless steel trowel or spatula) or with a plastering machine a first layer of structural mortar for a thickness of about 1.5 cm, leaving the surface sufficiently rough to allow the adhesion of the next layer. Position the alkaline-resistant fibreglass mesh from the Kimitech WALLMESH range, resting it on the still-fresh mortar. Proceed to create holes of a suitable diameter, at least 4 per m2. Insert the Kimitech PLUG VR connector and grout the hole with Kimitech EPOXY CTR or Kimitech VINYL CTR epoxy resin. Apply a second layer of mortar to a thickness of approximately 1.5 cm.