Basic INTONACO

Basic INTONACO It is CE marked according to the requirements of UNI EN 998-1 as GP mortar.

Basic INTONACO has to be mixed with drinking water in the quantities shown in the table. It is advisable to introduce 3/4 of the required water into the mixer, adding the product and the remaining water continuously, until the desired consistency is achieved. Mix carefully until you get a perfect amalgam. The product must not be added during preparation and laying with no other binder. Apply with normal manual or mechanical equipment. Do not mix the product by adding water once it has started setting. In the case of mixing with plastering machine (standard models), load the hopper with Basic INTONACO and adjust the flowmeter at a flow rate of 5-6 l / min, depending on the machine used, until the desired consistency is achieved. Apply Basic INTONACO from a distance of about 20 cm, from the bottom of the wall to the top, evenly. For plaster thicknesses greater than 20 mm, the application must be made in several coats, applying successive layers on the previous non-wrinkled layer (maximum thickness achievable 40 mm). Basic INTONACO must be applied on clean, dust-free surfaces, inconsistent parts, paints, grease and any other material that could affect its good anchoring