Kimistone C 957

The product is ready-to use and it can be applied using a brush or using pads moistened with the product. Ammonia can be added to remove stains caused by greasy substances. When applying with a brush, the support should be dry and dirty areas saturated properly. Scrub gently until a foam forms. Leave to take effect for 15 to 45 minutes, being careful that the surface to be cleaned doesn't dry out. Rinse with a very low pressure washer and repeat as necessary. Perform preliminary tests to find out the correct contact time. When surfaces are to be treated with pads moistened with the product, mix the undiluted product with cellulose pulp or sepiolite in a suitable container until the formation of a malleable paste . Apply this paste after an application on the sruface of the pure product. Cover with nylon film and leave to take effect. After the suitable time, remove the paste and rinse with clean water. Deionized water is always recommended for the best result. When using this technique, contact time should be checked with a preliminary test before start the real application.