Kimicover 601P

Kimicover 601P, conforme ai requisiti della EN 14891, è marcato CE come rivestimento protettivo tipo C secondo la EN 1504-2, principi di intervento MC e IR e marcato CE secondo la ETAG 005-6.

As for existing bituminous membrane, it will be necessary to evaluate from time to time whether to proceed with the removal of the membrane (especially if the membrane is deteriorated) or with localised restoration. In the first case, once the membrane has been removed, clean the substrate to remove dust, grease, inconsistent parts, detachment and poor mechanical characteristics and any other material that could compromise the good anchoring. Repair any deep and extensive irregularities (gravel nests, casting leaks etc) with suitable mortar, after priming. If you decide to leave the membrane: check the correct adhesion of the membrane; reinforce through heat treatment the non-degraded detached parts; remove any deteriorated parts and place a new membrane to seal the missing/removed parts; any protective varnishes, if of an acrylic nature, well adhered and not chalking, may not be removed, in all other cases (reflective and/or deteriorated paints) will be removed with appropriate techniques (mechanical/chemical or thermal treatments: contact the technical data sheets of the materials used); acid wash of the surface with Soluzione P. Kimicover 601P is a ready-to-use one-component product and can be applied with a brush, roller or airless pump in at least two coats, 12 hours apart. For the colored versions, the mixing of the powder oxides must take place gradually adding the pigment and mixing with a whisk mixer at low speed for about 3-5 minutes up to the complete homogenization of the color. In case of regular and perfectly flat substrates, Kimicover 601P can be applied without reinforcement mesh, otherwise where the product could be applied in uneven thicknesses, use Kimitech 120 mesh impregnated in the first layer of product still fresh. Use Kimitech 120 mesh impregnated in the first layer of product as long as it is fresh for local reinforcements in areas subject to high movements, in correspondence with joints and cracks. The system is able to guarantee walkability without additional protective finishings. If you wish to perform an upper tiled surface, provide a suitable layer of adhesive bridge and alkali barrier, by dusting quartz dry sand, Kimifill MP, on a special additional layer of fresh product (respecting a consumption of 300 g/sqm).